Three problems related to blind spot detection have been reported for the 2010 Ford Fusion. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2010 Ford Fusion based on all problems reported for the 2010 Fusion.
Driving home from the dr. 's office the vehicle's rpm suddenly began to increase yet the vehicle was not moving faster; the wrench icon came on, the vehicles blind spot warning came on, the speedometer went to zero and the vehicle continued to move forward at regular speed. With less than one mile to get home we were able to continue to drive the vehicle. When the vehicle was shifted into reverse to back the car into the garage, the transmission made a loud bang and jerked the car. The vehicle was driven into the garage. The fluids were checked and all are good. The vehicle was then started again and shifted into drive and the loud bang and jerk happened again. The vehicle has not been driven.
Electronic power steering systems failure (2010 Ford Fusion hybrid) due to issues of excessive heat on the motor), power steering locked. I was on hwy90 when the steering locked, I almost got in big accident on the hwy 90.
I was driving down the road and all of the sudden a warning light alerts appeared and said power steering assist fault. Then the car suddenly because very difficult to turn. Followed by traction control warning. I have service the vehicle as required and have records it has been serviced in a timely manner for its life time.