Three problems related to brake light on have been reported for the 2012 Ford Fusion Hybrid. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Ford Fusion Hybrid based on all problems reported for the 2012 Fusion Hybrid.
This is 3rd of 3 complaints because car was taken to dealer three times for three incidents with same symptoms. (I don't recall the temperature. Wunderground. Com recorded 10 deg f as the low. ) as with the first incident on Feb 16, the following occurred: started car from being cold overnight. Let engine run no more than 3 minutes prior to backing out of drive way. Made two successful stops. Drove 3/8 mile from last stop while traveling at 30 mph. Slowed to make right turn on desired street because traffic light was green. While turning brake warning light illuminated. Abs failure, stability control and traction control failure lights illuminated. Vehicle was very hard to stop with foot brake. Loss of all power assistance for stopping. But was easier to stop since repair from previous repairs on 2/16/15 and 2/23/15. Dealer recorded abs system test and diagnostic pinpoint test for the third time, contacted hotline id 108388128, for abnormal diagnostic pinpoint testing, connector access, c135 and c1602, performing abs bleeding and calibration twice, with abnormal circuit testing, load test while measuring voltage drop across circuits cca22 and vca22, per hotline, both elements are bright with no measured voltage drop, also abnormal road testing and verification due to intermittent concerns, before and after repairs, replaced the abs control module, performed programmable module installation and calibration again, ppt, p8, road test, verified repairs. Currently, with 28673 miles on March 21, the vehicle has performed flawlessly since this 3rd of 3 service visits.
This is 2nd of 3 complaints because the car was taken to the dealer three times for three incidents with same symptoms. Temperature was -3 deg f exactly as was on the previous complaint. Started car from being cold overnight. Let engine run no more than 3 minutes prior to backing out of drive way. After two successful stops and while accelerating to around 15 - 20 mph, brake warning light illuminated. Abs failure, stability control and traction control failure lights illuminated (left off stability control warning from previous report). Vehicle was very hard to stop with foot brake. But was easier to stop since repair from previous week on 2/16/15. Dealer recorded abs system test, c0022, abs pinpoint test p, circuit test brake booster solenoid, intermittent brake booster solenoid operation per ppt p6, replaced the brake booster assembly per ppt p7.
Temperature was -3 deg f. Started car from being cold overnight. Let engine run no more than 3 minutes prior to backing out of drive way. Made two successful stops. Drove 3/8 mile from last stop while traveling at 30 mph. Slowed to make right turn on desired street because traffic light was green. While turning brake warning light illuminated. Abs failure and traction control failure lights illuminated. Vehicle was very hard to stop with foot brake. Loss of all power assistance for stopping. Dealer recorded abs system test, c0022, abs pinpoint test p, circuit test, excessive resistance between pins 17 and 31. At abs module connector c135, 3. 3 ohms, trace, removed and installed pcm and master cylinder to access and repair wire circuits cca22 grey with yellow and vca22 green with brown, green corrosion at connector c1602 pins 3 and 4 near the brake booster solenoid connector.