Two problems related to car stall have been reported for the 2013 Ford Fusion Hybrid. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2013 Ford Fusion Hybrid based on all problems reported for the 2013 Fusion Hybrid.
My wife and I were entering a parking lot with the Ford Fusion Hybrid and slowed down, then started to slowly accelerate, the ffh wouldn't go forward normally and sort of stalled. My high voltage battery state was low (1/8 charged) and the car had about 3/4 tank of gas. It began with a series of surges that were caused by the car not knowing which propulsion source to use. It tried the gas engine, surged forward a few feet then tried to switch back to the electric motor, etc, - this happened about 6 times before I could get it to surge out of the driveway and park safely. I put the car in park and pushed the gas pedal trying to force the gas engine to take over and that caused an engine stutter and again the car tried each source of power - I turned the key off. Upon a restart it was as if nothing was wrong, it ran normally so I ran a Ford vehicle health report (vhr) while sitting in the car idling, that report is sent to my Ford owner's account, I did this to try and catch any errant dtc's (trouble codes). After that I restarted the car into the engineering test mode to show my digital dash display's internal readings, no dtc's were present there either. We finished our business and drove the 20 miles home without any problems, all normal. That was the first time this has happened and is a very unsafe situation.
The contact owns a 2013 Ford Fusion Hybrid. While driving 35 mph, the stop safe warning indicator illuminated and the vehicle stalled. The vehicle was able to be restarted and was towed to the dealer. The manufacturer was made aware of the failure. The failure mileage was 4,400. Updated 10/07/lj the dealer concluded the cam shaft sensor failed. Updated 10/21/14.