Table 1 shows one common electrical system related problems of the 2026 Ford Ranger.
| Problem Category | Number of Problems |
|---|---|
| Electrical System problems |
After arriving in carson city from reno, nv and running errands on local city side streets the vehicle began making a loud ticking noise which transitioned to a whomp/whomp/whomp noise. I pulled over at the nearest opportunity into a business parking lot and the vehicle brakes immediately locked up. I received the following error messages on screen; > anti lock brake system failure >hill start assist failed >electric parking brake failed >collision assist unavailable >check engine brake light >I checked documentation for release of parking brake and followed directions and the brake would not release. After multiple attempts the brakes would not release. Next I tried putting the vehicle into reverse and the brake finally released. All warning lights now remain on and brakes pull to the rights when applied.
When setting up my vehicle for neutral towing behind my motorhome and having parts installed for the proper operation of my turn signal and brake lights when vehicle is flat towed it was found that for it to happen were the brake lights do not override the turn signal when both activated at the same time you have to let the vehicle enter into a sleep mode for 10 minutes with the key fob completely isolated from the vehicle for 10 minutes. If you stayed near the vehicle or approached with the key fob closer than 30ft it would come out of the sleep mode and when pushing on the brake pedal and using your turn signal at the same time from your motorhome you would override the turn signal with the brake lights. Normal checks for RV'ers would not identify this issue as you would stand behind the vehicle you are towing to check right and left turn signals then shut them off and check the brake light then final check would be rear, front and marker lights never pushing the break and having the turn signal on at the same time. This is a safety issue for anyone behind you as they can see you are braking but not be aware you are turning if you have awaken your vehicle modules by it getting a signal from the key fob. This issue was found and verified by my installer and myself when checking as to why the turn signal would shutoff at the same point I pushed the brake pedal in my RV. The manufacturer has no information in its manually about this 10 minute delay nor that the fob can keep the delay from occurring by being near the vehicle. When you actually keep the vehicle in the sleep mode what happens is the active turn signal blinks and the opposite light indicates a brake light.