GMC C2500 owners have reported 2 problems related to axle assembly (under the power train category). The most recently reported issues are listed below.
Vehicle started to make noise. Consumer took the vehicle to the dealer to have the tires checked. Front tire axle nut was found to be loose. Also, the rotors and bearings had to be replaced.
See
all problems of the 2003 GMC C2500
🔎.
The contact complained about a brake problem. Rear rotors rusted. Dealership said that this was normal wear for the rear rotors. The gm customer service told him to take it back to the dealer, and all they would tell him was that he needed to replace rotors and rear brake pads because they could not turn them over. Left rear axle seal leaked. The slip yoke and rear u-joint on the rear driveshaft were replaced because they were causing a chattering feeling when the wheel was turned.
See
all problems of the 2002 GMC C2500
🔎.
| Problem Category | Number of Problems |
|---|---|
| Driveshaft problems | |
| Transfer Case problems | |
| Automatic Transmission problems | |
| Axle Assembly problems | |
| Axle Shaft Seal problems | |
| Transmission Stuck In Gear problems | |
| Universal Joint problems | |
| Manual Transmission problems | |
| Differential Unit problems | |
| Transmission Not Go Into Gear problems |