Front Suspension Wheel Bearing Problems of GMC Sonoma

GMC Sonoma owners have reported 5 problems related to front suspension wheel bearing (under the suspension category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of GMC Sonoma based on all problems reported for the Sonoma.

1 Front Suspension Wheel Bearing problem of the 2000 GMC Sonoma

Failure Date: 05/15/2006

Passenger and driver seats in my 2000 GMC Sonoma have seat positioning controls and locking mechanisims that do not always lock properly and/or get jammed up and have broken. A friend was sitting in the passenger seat and it failed to lock into place to keep it from sliding forward. I adjusted the bolts that fasten the seat to the floor of the vehicle to help 'realign' the seat frame so that the mechanism that keeps the seat from siding front and back would keep the seat locked into position once the seating distance is set. Also, the reclining handle on the passenger side broke off, not allowing for seat back support angle adjustment on the passenger side. The driver's side seat back support adjustment lever often 'sticks' or 'locks' into position. . . . Not allowing for seat back rest adjustment. Rear differential sometimes locks up and or slips and shakes and makes noise. . . Especially when sideways force is applied. . . Such as when turning in a curve or circular fashion with the vehicle in motion. Both tailgate support cables broke on the truck. Front driver's side bearing had excess wear and had to be replaced at 65 000 km. Driver's side wiper arm got dislodged from the shaft that turns it and was knocked out of position on 2 occasions. Power steering fails for short intermittent periods when the vehicle is first started from a 'cold' and 'warm' state and the steering becomes stiffer and less responsive. Most noticable at slower vehicle speeds.

See all problems of the 2000 GMC Sonoma 🔎.

2 Front Suspension Wheel Bearing problem of the 1999 GMC Sonoma

Failure Date: 08/01/2000

Vehicle would shimmy and front end would shake visibly. Dealer replaced front ball joints/ idler arm and tie rod ends at34000 miles. At this time, same 3 components needed to be replaced plus front wheel bearings. The vehicle had same problem as in Aug 2000. Also, tires were wearing out on the outside. 3 different GMC dealers told consumer that GMC was aware of the problem, but refused to do anything about it.

See all problems of the 1999 GMC Sonoma 🔎.

3 Front Suspension Wheel Bearing problem of the 1998 GMC Sonoma

Failure Date: 03/23/2000

1998 GMC Sonoma, front wheel bearings fail.

See all problems of the 1998 GMC Sonoma 🔎.

4 Front Suspension Wheel Bearing problem of the 1998 GMC Sonoma

Failure Date: 09/10/1998

Bearings squeaking. Nlm.

5 Front Suspension Wheel Bearing problem of the 1998 GMC Sonoma

I had the front wheelbearings replaced between 30&40thousand under warranty. Now at 80 thousand thay have gone again. I think dirt is able to get in threw the anti-lock sensor . At 400 bucks a wack this is crazy. Pleas look into this . Thank you and have a good day.




Fuel Economy of Sonoma Vehicles
Sonoma Service Bulletins
Sonoma Safety Recalls
Sonoma Defect Investigations