Lane Departure Related Problems of the 2025 GMC Yukon

Table 1 shows two common lane departure related problems of the 2025 GMC Yukon.

Table 1. Lane Departure related problems of GMC Yukon

Problem Category Number of Problems
Warning problems
1
Blind Spot Detection problems
1

Warning problem #1

This has happened twice. Once in November 2025 and then in January 2026. With super cruise engaged while going around a curve super cruse disengages and the steering wheel turns to driving straight. You have about one or two seconds to take control or crash. This happened while driving about 70 mph on interstate I 70 and next on ohio 122 going about 45 mph. On I 70 it was a gentle curve and on 122 it was a much sharper curve. Super cruse must give a warning that it about to disengage that is much longer than one or two seconds.

Blind Spot Detection problem #2

While driving on a highway, the vehicle intermittently experienced a sudden loss of engine power during acceleration, accompanied by a flashing check engine warning light. The most serious event occurred while merging into traffic, when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. After pulling over and restarting the vehicle, normal acceleration temporarily returned, but the problem has recurred multiple times. The malfunction appears to be related to an engine misfire or powertrain fault because the check engine light flashes during the events and an obd scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and typically occurs after the vehicle has been driven for approximately 10–45 minutes. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times for diagnosis. The dealerships have reported that they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been inspected/diagnosed through authorized service channels, but the underlying cause has not been identified. The failure continues to occur intermittently and is a safety hazard because it affects acceleration in traffic. Incident list 10/25/2025 (~12:25 pm; ~3,108 miles) — while accelerating to merge onto a highway, the vehicle lost power and the check engine light flashed. The driver pulled over, shut the vehicle off, restarted, and the condition temporarily resolved, allowing the trip to continue. 10/27/2025–11/04/2025 — the same loss-of-power/misfire behavior recurred intermittently, typically lasting a few minutes before clearing. 11/05/2025 (~8:01 am; ~3,641 miles) — the check engine light flashed again and symptoms consistent with misfire/loss of power were present. The.


Lane Departure related problems in other GMC Yukon model year vehicles:



Yukon Service Bulletins
Yukon Safety Recalls
Yukon Defect Investigations