Front Seat Power Adjust problems of the 1998 Honda Accord

1998 Honda Accord w/ 8 way power seat. Have had two weld failures of front torque tube to lift levers. First failure was left hand corner two years ago. Repaired this break myself with tig weld, the dealer would not warrant this repair because the vehicle was beyond Honda's 36mo/36k warranty. Second failure occurred on center lift lever this past November, 2004. My seat freely and loosely rocks back and forth the normal front seat tilt travel. I asked my local Honda dealer about the replacement mentioned by Honda in defect summary NHTSA action number pe02072. I was told my Accord had too many miles (140,000). My replacement cost for this over $300. 00 or disassemble the frame and redo all the "cold" welds. The welds on this seat frame are defective. None of them appear to have proper penetration. This is a safety defect, similar to a defective safety belt. I have not seen any cooperation from my Honda dealer contrary to Honda's statement, they are not providing ". . . No-cost reinforcement for the seat. . . ".

I have a 1998 Honda Accord 4-door. Sometimes the seat belt on the driver's side does not recoil when I remove it. I gets hung up in the switch that moves the seat back. On the date below, I had my son in a forward facing car seat in the middle rear sear. I parked and unclipped my seat belt and opened the trunk. I got out of the car and shut the door but didn't realize that the seat belt was pushing against the seat back switch and lowered the seat back all the way down. It caught my son's foot between his car seat and the seat back. He was not seriously hurt, but this could have been much worse. It only took the time from me to get out of the car and go to the trunk to retrieve his stroller for this to happen.