Four problems related to brake disc rotor have been reported for the 2003 Honda CR-V. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2003 Honda CR-V based on all problems reported for the 2003 CR-V.
The contact owns a 2003 Honda Cr-v. The contact stated that the rear brake pads needed to be replaced and the rotors needed to be resurfaced. The inspector stated that the rear pads had separated from the plate in which they were attached. The contact stated that the pads were purchased with the vehicle. The current mileage is 31,940 and failure mileage was 31,840. The consumer was informed the front pads were ok. Updated 09/05/07.
I have now taken my 2003 crv in for the third time because of vibration in the steering wheel. The first time they machined the rotors and the second time they replaced them. Now, after about 15,000 miles, they are telling me they need to be replaced again. Something has got to be wrong here.
From day 1 my brakes did not seem right. I had a very bad vibration in my brakes from probably 15,000 mi. At approximately 17,000mi the dealer machined or turned the rotors and replaced the brake pads. Now again at 35,000mi the vibration in my brakes are back. Dealer wanted to machine and turn the rotors once more, but we argued that this is not normal,a nd they agreed to replace them at 35,600mi. I have done some research and found that there are a lot more Honda owners with this problem. I have always owned Hondas in the past and never had this problem.
Brake caliper did not release, causing the <a href=". . Read more...