Four problems related to warning have been reported for the 2020 Honda Passport. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2020 Honda Passport based on all problems reported for the 2020 Passport.
The front multipurpose camera system failed, triggering multiple safety warning lights simultaneously, including acc (adaptive cruise control), lkas (lane keeping assist system), and related camera-dependent safety systems, along with a "multipurpose camera unit" fault code u3000-49. The failure pattern has been intermittent and inconsistent: on some drives, warning lights are absent at startup and appear after several minutes of driving; on other occasions the warnings appear immediately at startup; duration before onset varies from trip to trip. This vehicle falls within the range covered by a prior Honda recall (recall 19-020 / NHTSA campaign for 2019-2020 Passport) addressing software programming errors in the front control module causing improper display of instrument panel and delayed or missing rearview camera images. The current failure presents similar camera-related safety system symptoms. A dealership inspection recommended replacement of the multipurpose camera unit at an estimated cost of approximately $2,000, without confirming the root cause of the failure. Safety concern: loss of acc, lkas, and related driver-assist camera systems while driving, with warnings appearing unpredictably during operation, some minutes into a drive rather than at startup, suggesting a fault that may not always be evident during a pre-drive check.
Multipurpose camera stopped working and most of the safety systems alerts are on now and don’t work.
The nidec oem part number 36160-tgs-a03-m1 has failed and causing all five of these alerts to appear as warnings: 1. Road departure mitigation problem 2. Collision mitigation problem 3. Lane keeping assist problem. 4. Auto high beam problem. 5 adaptive cruise control failure I don't know if the nidec part is oem from Honda and I believe the materials used by nidec are creating the issue. I thought the Honda oem part for this camera came from bosch. The german part appears to made from aluminum, the nidec part might be a plastic or other material. I am researching the failure rate on your part as I don’t believe there is a heat sink as part of the configuration and the part seems to be out of stock everywhere I look.
Front radar camera is broken after 100000 miles. Errors include: adaptive cruise control, lane keeping assist, brake system, road departure mitigation system, auto high beam, collision mitigation.
| Warning problems | |
| Assist problems |