Crankshaft Position Sensor problems of the 2003 Infiniti I35

The contact owns a 2003 infinity I35. The contact stated that while driving at 25 mph, the vehicle stalled without warning. The vehicle was able to be restarted, but it stalled again. The vehicle was towed to an independent mechanic where it could not be diagnosed. The failure occurred on another occasion as the slip, tcs and the service engine soon warning lights illuminated. The vehicle was taken back to the independent mechanic where it was diagnosed that the crank position sensor failed and needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was 158,000.

I've had the same problems that other Infiniti I-35s have experienced in regards to losing power, engine cutting off and lack of bracking. My car initially stalled while I was parked at a red light. After a few attempts to restart, it finally did. I made an appointment to see the dealer about this problem four days later. While driving to the dealer, my car engine lights all lit up and the car stalled and I had no braking ability. Fortunately, I was going only about 10 mph when this happened and was able to pull over to a lane without cars and applied my parking break to stop the car. After five minutes of attempting to restart, it finally did. I was only two miles from the dealer, so I slowly drove it there. They told me the problem was both crank sensors along with the crank shaft. I had them replaced at a cost of close to $1000. It seems to me that if there are so many complaints regarding this problem, it should be looked into as a safety recall issue. If I were going faster, I could have crashed into someone. One week before this happened, I was driving through mountain roads with many twists and turns. If this happened during that drive, I would probably be dead by now.