Seat Broken Problems of Infiniti M45

The bracket on the left side of the drivers front seat has broken. The seat now sags several inches in the left/ rear side. This is placing substantially more stress on the right side's bracket. This bracket failed while driving the car.

See all problems of the 2003 Infiniti M45 🔎.

The drivers side bottom metal seat bracket broke while in motion. The seat is now completely unsupported. The seat moves when brakes are applied.

See all problems of the 2007 Infiniti M45 🔎.

While driving at normal highway speed, my drivers seat suddenly collapsed onto the floor on the left side of the seat. After regaining control of the car, I pulled over to find that the seat bracket had broken. The seat is completely detached from the frame and now moves freely up and down. I took the car to the dealership and without even looking at it, they said that I would need a new drivers seat at a cost of $2000. 00. The technician then stated that this was a common problem on 2006-07 Infinities. I started researching this online and found that there are thousands of complaints and serious safety issues involving broken seat brackets in these vehicles. Infinity accepts no responsibility for this problem and refuses to even attempt to correct the problem.

See all problems of the 2006 Infiniti M45 🔎.

River's seat collapsed and came off tracks while car was being driven. Defective welds (as stated by Infiniti certified dealer service center) holding seat assembly determined to be cause. Infiniti diagnosis; seat track broken. Requiring replacement of front adjuster assembly; part # 87450-eh00a. Cost of part $~1000 to install; $~300. This is a Nissan/Infiniti problem reported previously to NHTSA on numerous occasions. Dealer service department stats that weld failure causes seat to collapse. Problem is longstanding, well documented, and known to Infiniti. In spite of this, no remediation, other than repair at owner's expense, has been offered by Infiniti. This weld failure is a serious safety related matter that is not the result of abuse, maintenance neglect, or overstress to seat or seat assembly. The has been acknowledged by repair personnel at dealership that carried out the repair.

Seat broke 1 month ago, and was leaning to right. While interstate driving, went to adjust the seat height, and the seat broke down to the ground. Had to pull over into emergency lane, and re-adjust mirrors, and steering wheel height. Seat will not move up/down anymore, and is planted onto the floor of the car.

Driver seat collapsed! as other stated, the weld broke and the seat collapsed during driving, causing a serious dangerous safety issue! Infiniti, please take responsibility about this! it's safety and it should be a recall!.

Frame on drivers seat broken causing seat to list to the left side. Previously repaired by dealer who informed us at the time that it could not be repaired again, it would need to be replaced at at cost of approx $1800. 00. Seat currently now needs replacement. This is a one owner vehicle and has been maintained by the dealership.

See all problems of the 2004 Infiniti M45 🔎.

Driver seat bracket broke and the seat slides and rocks when driving, unsafe ## VIN failed ## Infiniti M45 2006 ##.

Infiniti has received many complaints about the broken driver seat leaning into the center console because it is well documented in the nicoclub. Com forum "2006 M45 seat leaning into glove box. " while my car was being serviced in 2008-2009 timeframe, I called Infiniti of willow grove PA and asked them to look at the seat because it seemed to rock when coming to a stop or accelerating. I was told they could not find anything wrong with the seat and I never thought much of it until it completely broke and my seat was leaning into the center console. I have two children and needed to get this matter resolved quickly for the safety of my family. The dealer told me there was nothing they could do and asked me to call Infiniti consumer affairs. The consumer affairs representative promptly took my contact info and said she would check with the manufacturer to see if there was money available to assist me despite my car being out of warranty. The representative said she would be in touch with me in about a week to tell me what the decision was. She called me back a few days later and said there was nothing they could do b/c the issue was not documented at the dealer and the car was out of warranty. She said the entire under carriage of the seat would require replacement at a cost of $1,200. Unfortunately, I do not have $1200 to put towards a $42,000 car so I ended up taking the seat apart myself and took it to a welder. The welder said the material used by the manufacturer was poor quality. I took multiple pictures of the broken seat bracket and had it professionally welded for $40 (much less than the $1200 quoted by the dealer and consumer affairs).