Table 1 shows one common vehicle speed control related problems of the 2011 Jeep Cherokee.
| Problem Category | Number of Problems |
|---|---|
| Vehicle Speed Control problems |
Upon exiting freeway on 2/05/14 car stalled without warning, making it difficult to steer because loss of power and brakes not fully functional I almost ran into street divider, I was able to steer to the side of the road, where I attempted to restart the vehicle. Vehicle did start and seemed fine afterwards. It happened again 4 days later again while exiting freeway off ramp again. I took the vehicle to the dealership where they hooked it up to a diagnostic and found no codes other then a software update they did they could not find a problem. I've read several complaints about this same type of stalling without warning on other Jeeps and no one has been able to get any help with this issue. I suppose not until someone dies from this malfunction of these Jeeps will Chrysler start to look into this problem and recall the part that is causing this to happen.
I bought a 2011 grand Cherokee from shave Jeep in thousand oaks, CA. The vehicle started to malfunction within days after purchase. It would seize up, usually at highway speed, stall out, thus losing power steering and brakes. I brought the car in for service about 8 times until I almost got hit by a big rig on the highway at night when my car died. The constant engine light reading was a camshaft position sensor. Chrysler techs attempted to resolve the problem without any luck. Unfortunately the dealer swapped out cars with me and I found out they sold this vehicle without telling the new owners of the major mechanical problems.