Table 1 shows one common electronic stability control related problems of the 2019 Jeep Grand Cherokee.
| Problem Category | Number of Problems |
|---|---|
| Electronic Stability Control problems |
The contact owns a 2019 Jeep Grand Cherokee. The contact stated that the exterior lighting system failed to operate as designed and malfunctioned. The contact stated that when he depressed the brake pedal, the brake light failed to operate as needed. The vehicle was taken to the dealer where it was diagnosed that the abs control module software was updated; however, the traction control system failed to operate as designed. The check engine, the abs, and the traction control warning lights were illuminated. The vehicle was taken to the dealer where it was diagnosed that the electronic stability control module needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure and the contact was informed that the VIN was not included in a recall. The contact was advised to call the NHTSA hotline for assistance. The failure mileage was approximately 71,145.
I was driving on the interstate when all service light came on and steering wheel locked up and the car began to power down. I almost crashed into a 18 wheeler because the steering wheel would not turn properly. I was able to pull over and the car would not move, switch gears, stop or start. My vehicle was serviced by Jeep twice in the past two weeks.
While driving the car with 750 miles the electronic stability control, abs, check engine, brake service antilock brake system lights all come on. While driving noticed car wasnt tracking miles then died on the interstate at approximately 70 miles per hour.