general problems of the 2011 Jeep Liberty

My vehicle was in motion and I was driving on a three lane street with a speed limit of 45 mph when the abs brake system suddenly seized. The brakes remained engaged and the only way I could drive my car was to put it in reverse, then neutral then drive. My entire drive home I could hear the brakes and whenever I had to stop at a stop sign the brakes would lock.

Brakes locked up 3/2017 had it towed to anderson Jeep in az. They replaced the abs module and hcu. 100 days later they locked up again in mn. Towed to forest lake Jeep. When tested it worked ok then later they drove it and it locked up while they were traveling down the road. Codes showed same parts have to be replaced. They don't feel confident that this will correct the problem. We are concerned that this will cause a safety problem in the future. The latest was on a city street while car was in motion.

The contact owned a 2011 Jeep Liberty. When the contact entered the vehicle and depressed the brake pedal, the vehicle surged forward, struck another vehicle, and crashed into a concrete wall. There were two injuries that required medical attention. The contact did not observe any warning lights illuminated. The air bags deployed. A police report was filed. The vehicle was not diagnosed nor repaired. The manufacturer was not notified of the failure. The failure mileage was unknown.

The contact owns a 2011 Jeep Liberty 4x4. The contact stated while driving approximately 48 mph he encountered a large puddle of water. The brake pedal was depressed and immediately the vehicle spun out of control causing the contact to crash into a nearby wall. The driver sustained bruises to the left leg. A police report was filed. The vehicle was towed to a towing facility until further investigation. The vehicle had not been repaired or diagnosed. The manufacturer was notified of the defect. The approximate failure mileage was 38,000.