general problems of the 2012 Jeep Liberty

The entire dashboard set of alarm lights go on as soon as the vehicle starts. The speedometer stops working, the hand break light is on so it appears as it actually activates it and it slows the vehicle impacting drivability, the radiator fan is constantly working, the 4wd mode is activated by default also impacting drivability, impossible to see if the car is overheating, and it could very well be that the airbags would not work if needed. This all adds to a very unsafe drive.

Front and back brakes lock up. Back driver side did it. Then stopped. Smoked from rubbing. Then quit. Now today July 3rd 18 front passenger locked up. Smoked from hot. Parked it went out later alittle better but the back driver and front passenger are still hotter. No lights no warnings. Just calibers not releasing good. Went out on highway yesterday fine. Today in town locked up.

All of the dashboard lights are on. Speedometer, odometer, gps, automatic door lock, remote start, cruise control, none of that works. Tire pressure warning lights are constantly flashing different pressures. Everything lights up upon starting and stays on while moving until it's turned off. This initially happened when I was driving on a highway, and my first reaction was that I didn't have any brakes. It was quite frightening. Subsequent to that the lights would go on and off intermittently, but after a few months they are now permanently on. The dashboard also makes a ping noise every minute or so. I purchased the car in 2017 and this had not been a problem until a few months ago. The known danger is in not knowing how fast I am going. The unknown danger is could the brakes at some point not work, or if I become involved in an accident will the air bags not deploy or will the engine at some point just stop running. I have been told it could be a faulty tipm. I also have a 2008 Jeep Liberty that does not have this problem, however it suffers from the same dashboard random ping noise.

My Jeep has had trouble switching from defrost to vent or floor since I purchased it. Recently I have been unable to use the heat in my Jeep and it is very cold in the mornings. I have been advised it is the hvac blend door actuator. I have read reviews online with a lot of people having the same issues and was also advised by a coworker that Jeeps have a lot of recalls for problems such as this. I would like to report the issue in the event the Jeep could be recalled for this before I spend a large amount of money trying to have it repaired. The heat will not work at all, it does not matter if the vehicle is in motion or sitting in park. My passenger window will not roll down when being attempted from the passenger side. The driver has to roll the window down. My Jeep was in park and another vehicle backed into it, slightly bumping the front bumper of my Jeep. My Jeep was in park with no passengers inside but rolled backwards several feet. The Jeep was barely tapped therefore, considering it was in park, should not have rolled backwards that far. I travel with kids in my vehicle, this is frightening.

"takata recall" this vehicle is a saftey hazzard unsafe due to abs notification system and causing brakes to drag and lock up. I purchased this vehicle at a so called 5 star Chrysler Jeep dealership and it was put on the lot with bad breaks that where metal to metal and a bad electrical system. I had to purchase new breaks which are being damaged due to abs malfunction causing the hit an miss causing the breaks to over work against the rotar drag and lock up. I was coming home on hwy and had to apply my breaks the break light came on and my breaks locked and I swerve off road to keep from rear ending another vehicle and shut off engine. This is a safety issue vehicle is unsafe and should not have been sold without breaks and electrical system being checked out.

I started off by driving down hill on highway 40. All vehicle lights lit up on dashboard, enging stalled, no brakes or steering. I shifted the vehicle to neutral and was able to come to a stop on the shoulder of the road when the vehicle started up the next hill. No turns, the road was straight. Turned the key off and restarted the vehicle, and the Jeep ran fine. Later that day in a parking lot, the same thing happened. Started the vehicle, started to pull out of the parking lot, all of the dashboard lights came on, the engine stalled and had no brakes or steering. Placed the vehicle in neutral until the Jeep came to a stop, turned the key off, then restarted the vehicle and the Jeep ran ok until we got home.

This is not the first time this issue has accured but I cann't rememer the dates but it is on record at the dealership. We have had this 2012 Jeep Liberty in the shop two other times with the same complaint but with the same results (nothing) !!!!!!!!!!when driving on wet roads and going into curves even at slow speeds (35 mph) when applying the brakes, the front brakes will lock up and the back brakes are not catching. . . Causing the Jeeps back end to slide around,, so we tried stopping on a level gravel lot and the front wheels will lock up but the back wheels will keep turning. We have had it to tim short Chrysler, Jeep, Dodge in hazard, ky and one mechinc says that there is clearly something wrong but another states that he test drove another like vehicle and this vehicle does same. And that he talked with star and roland and both stated that this is normal operation. No codes, no problem found at this time. So I received a statement with the signature of mechinc dwayne slone (servie manager) and trent short (general manager). This is very dangerous and if this in "normal operations" then something needs to be changed!!!!!!!!!!!!!!!!!!!!!!!!! please help,,, has there been any other complaints with this same problem?.

The contact owns a 2012 Jeep grand cherokee. The contact received a notification for recall NHTSA campaign id number 14v154000 (service brake , service brakes, hydraulic). However, the contact was not able to have the vehicle serviced under the recall because the part needed was unavailable to perform the repair. The manufacturer was notified of the problem. The contact had not experienced a failure.