Front Suspension Stabilizer Bar problems of the 2006 Jeep Wrangler

I was traveling at about 45 mph on open road when the vehicle shook so bad I pulled off the road, because I had trouble hanging on to the wheel. I looked this up and it was called a death wobble. I bought the vehicle used in 2013 after trading in a 1999 Wrangler that I never had such a problem with. I have replaced the stabilizer bar and stabilizer link bushings, track bar and bushings and still get a wobble but not as bad. There is certainly something wrong but no one is admitting it. Why does it take someone getting seriously injured or killed to get the problem recognized and fixed.

I purchased the Wrangler in about October of 2009. Since then, the fuel tank over-spills when it is filled at the gas pumps. It caused damage to the paint and to the plastic wheel guard. Of greater concern is death wobble. The front end violently shakes at highway speeds from time to time. The vehicle is hard to control. I made attempts in 2013 and 2014 to fix it, only to have the problem return. In 2013 the steering damper and steering stabilizer bar was replaced. In 2014, the tires were replaced and aligned. The problem returned this year, and is at its worst.

The contact owns a 2006 Jeep Wrangler. The contact was traveling 40-45 mph when the front end started to shake. The vehicle was taken to a private mechanic. The mechanic confirmed the front end stabilizer bar needed to replaced. The manufacturer was not contacted. The vehicle was not repaired. The failure mileage was 70,000 and the current mileage was 72,000.

The contact owns a 2006 Jeep Wrangler. While driving approximately 35 mph, the contact drove over a road bump when the front end of the vehicle began to shake vigorously. The vehicle was taken to an independent mechanic for diagnostic testing. The mechanic replaced the stabilizer bar twice. The vehicle was not repaired. The approximate failure mileage was 72,000.