Body problems of the 2021 Jeep Wrangler

The car which is barely driven, suddenly caught on fire while parked in my home driveway after sitting there for close to 8 hours. So the car wasn't in use at the time. It's completely gone.

While driving higher speeds (45 mph+) I have had my vehicle start shaking very violently which results in me having to slam on my breaks to gain control of my vehicle. When this happens I have been traveling on the highway or interstate which puts other drivers at risk due to me unexpectedly having to come to a halt to gain control of my vehicle. I have taken my vehicle to the mechanic multiple times (dealership twice and local mechanic twice) and I have had everything replaced on the front end that could cause this and it is still happening. Steering dampener has been replaced twice in a year. Mechanic seems to believe that there is a design flaw in the vehicle that is causing it at this point. There is no warning message or anything that gives me any warning. I am scared to drive my vehicle on the highway or interstate.

It started with the engine sounding louder then normal. Then a bad smell in the cab of the vehicle. Later found out it was a exhaust leak that was getting into the vehicle causing headaches and other symptoms of carbon monoxide. Also note the burn marks around the broken bracket that could cause a fire if not mechanically inclined to notice. Not check engine light for this. But when I spoke to the dealership it wasn't new to them. Apparently this has happened to alot of the ecodiesel Jeep and gladiators. A common problem that should be resolved before and life threatening injuries result in loss of consciousness or fire.

On 9/29/24 with the rear window removed and the top in a closed position while driving highway speeds, the driver side rear window of my vehicle, without warning, flew off and moments later the rear driver side support flew off. The side windows of the vehicle had previously never been removed. It was a shocking experience that left me quite shaken, yet out of control to mitigate. Fortunately, there were no vehicles immediately behind me taking the impact of flying car parts, however, had there been this could have been deadly. The dealership will not be able to fully access the vehicle until 10/16/24. Upon speaking to the service manager they will take a quick look at it today (9/30).

I made appointment with galena Chrysler Dodge Jeep ram fiat, fort myers, FL for may 4, 2023 at 9 am to repair the frame stud defect (28a/NHTSA 23v-191) on this vehicle. After having received no communication from this dealer after 5 days, I went to pick up the vehicle the evening of may 8, 2023 and discovered no attempt to remedy this defect had been made. My plans are to drive this vehicle from FL to WI for the summer months later this week. Besides making you aware of this situation, I want to have it on the record that I attempted to have the defect remedied in the event it is involved in a motor vehicle accident and would catch fire.

Issue 1--open recall since 2/23/2023 with no remedy available (over 5 months) from manufacturer: in some circumstances, the clutch pressure plate may become overheated through friction, which may lead the pressure plate to rapidly fracture. When a pressure plate fractures, it may result in cracks or holes in the transmission case, allowing heated debris to be expelled from the transmission case. Safety risk heated debris expelled from the transmission bellhousing may come in contact with an ignition source in the vehicle or surrounding area, potentially leading to a fire. A fire can result in increased risk of occupant injury and injury to persons outside the vehicle. Issue 2--technical service bulletin (TSB 31-002020) dated 10/27/2020 related to rust. This issue was reported to my dealer may 2023 and over 60 days later, the burden is on me to take to a body shop for an estimate to be covered under warranty. Said body shop has had claims open on same issue >120 days with no parts available and no date of parts available. Due to this cosmetic issue on the vehicle, I am unable to trade it in to a dealership for a new car without receiving a lower trade in value. I am now stuck driving a vehicle with cosmetic issues, as I do not want to lose thousands on trade in due to a cosmetic issue that is of no fault of my own.

Issue 1--recall 19a/NHTSA 23v-116 n some circumstances, the clutch pressure plate may become overheated through friction, which may lead the pressure plate to rapidly fracture. When a pressure plate fractures, it may result in cracks or holes in the transmission case, allowing heated debris to be expelled from the transmission case. Safety risk heated debris expelled from the transmission bellhousing may come in contact with an ignition source in the vehicle or surrounding area, potentially leading to a fire. A fire can result in increased risk of occupant injury and injury to persons outside the vehicle. Issue 2--technical service bulletin 31-002-20 issued 10/27/2020 corrison, rust and chipping of pain which is not only a cosmetic issue but rust can spread and weakned metail in the vehicle making it susceptible to additional premature damage and wear. Reported to dealer in may 2023 with as of this date open service ticket and parts not availble to repair--cosmetic issue is preventing me from receiving full value as a trade in on another vehicle.

Beginning in January 2023 with approximately 20,000 miles our leased 2021 Jeep Wrangler began to shake uncontrollably while driving on the highway at speeds over 60 mph. The shaking was so significant that while trying to safely guide the car off the highway my husband was shaken into the guardrail causing damage to the right front bumper. We are horrified that Jeep has had this problem for so long and there's no public notification of the problem.

The contact owns a 2021 Jeep Wrangler. The contact stated that the 3-piece hard-top was uneven and he could hear outdoor wind while driving. The contact took the vehicle multiple times to the local dealer to be inspected however, the mechanic was unable to determine the cause of the failure. The contact replaced two of the hard-top pieces but continued to experience the failure. The manufacturer had been informed of the failure. The failure mileage was approximately 15.