Air Brake Abs Warning Light Problems of Jeep Wrangler

The contact owns a 2012 Jeep Wrangler. The contact stated that while operating the vehicle the abs, traction control and check engine warning lights had remained illuminated. The contact indicated that while pressing the brake pedal to stop, the brake pedal extended to the floor causing the braking distance to become extended. The vehicle was taken to the local dealer who diagnosed that the abs module was faulty and needed to be replaced. The vehicle was not yet repaired. The manufacturer was notified of the failure but no assistance was offered. The failure mileage was 55,000.

See all problems of the 2012 Jeep Wrangler 🔎.

The contact owns a 2018 Jeep Wrangler. The contact stated driving 30-35 mph, the abs warning light, the check engine warning light, the traction control warning light, and other unknown warning lights were illuminated. The odometer became inoperable. The vehicle lost power steering functionality and shifted into accessory mode. The contact was able to veer to the side of the road. The contact stated that the vehicle failed to respond while attempting to drive. Additionally, the vehicle failed to shut off as needed. The contact stated that the vehicle remained in accessory mode for 15 minutes and restarted independently. The contact stated that the failure had been reoccurring. The vehicle was taken several timed to the Ford dealer where it was purchased; however, the dealer could not duplicate the failure. The Jeep dealer was notified of the failure and advised the contact to take the vehicle in to their location for a diagnostic test. The vehicle was not diagnosed nor repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 40,000.

See all problems of the 2018 Jeep Wrangler 🔎.

The contact owns a 2021 Jeep Wrangler. The contact stated that while driving at 30 mph, the brake system failed as both the anti-lock brake system (abs) and electronic stability control (esc) warning lights appeared on the instrument panel. Due to the failure, the vehicle was towed to the dealer where two attempts were made to replace the abs; however, the failure persisted after each repair. The manufacturer was informed about the failure and they acknowledged that the failure was a known issue with his model vehicle; however, there was no repair for the failure. The vehicle had yet to be repaired and remained in the possession of the dealer. The failure mileage was approximately 28,000.

See all problems of the 2021 Jeep Wrangler 🔎.

The contact owns a 2022 Jeep Wrangler. The contact stated that after starting the vehicle, the abs warning light was illuminated. The vehicle was taken to a local dealer, where it was diagnosed that the abs module needed to be replaced. The vehicle was repaired; however, the contact stated that the failure reoccurred after starting the vehicle. The vehicle was then taken back to the dealer, where the failure code was cleared and it was diagnosed that the abs module needed to be replaced again; however, the part for the repair was on backorder. The vehicle remained at the dealer awaiting parts for the repair. The manufacturer was made aware of the failure. The approximate failure mileage was 3,000.

See all problems of the 2022 Jeep Wrangler 🔎.

The contact owns a 2016 Jeep Wrangler. The contact stated that while starting the vehicle, the abs warning light illuminated. The vehicle was not diagnosed nor repaired by an independent mechanic or dealer. The manufacturer was made aware of the failure and informed the contact that there was no recall associated with the VIN. The failure mileage was approximately 102,000.

See all problems of the 2016 Jeep Wrangler 🔎.

The contact owns a 2021 Jeep Wrangler. The contact stated that while at a stop light and attempting to accelerate the vehicle would not drive forward and the gear shifter lights began blinking. Suddenly the vehicle would lurch forward and backwards crashing into both the vehicles in the front and rear and a third parked vehicle before finally the driver was able to shift into park and turn the vehicle off. During the incident the stability control, abs, and traction control warning lights had illuminated. The vehicle was later driven to the police station but the warning lights were still illuminated. During the incident no injuries were reported and a police report was taken. The manufacturer was contacted and later retrieved the vehicle for evaluation. No further information was available. The local dealer was also notified of the incident. The failure mileage was 15,000.

The contact owns a 2016 Jeep Wrangler. The contact stated while driving 40 mph, the brakes failed to operate as intended. There was no warning light illuminated. The vehicle was driven to a stop and the contact smelled rubber burning with a little bit of smoke. The vehicle was driven to an independent mechanic and was repaired. The failure recurred and the vehicle was taken back to the independent mechanic. The contact was informed that the abs module was sticking and needed to be replaced however, parts were on back order. The manufacture was not notified of the failure. The failure mileage was 60,000.

The contact owns a 2016 Jeep Wrangler. The contact stated while driving at various speeds, the traction control and abs warning light illuminated. The contact stated that as the warning lights illuminated, the vehicle decelerated and then attempted to regain traction control. The contact stated that the failure was intermittent. The vehicle was not diagnosed nor repaired. The dealer was contacted and scheduled an appointment for may 2021 at 10:00 am. The manufacturer was not made aware of the failure. The failure mileage was approximately 59,400.