Wiring problems of the 2014 Kia Motor Sorento

Two problems related to wiring have been reported for the 2014 Kia Motor Sorento. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2014 Kia Motor Sorento based on all problems reported for the 2014 Sorento.

1 Wiring problem

Failure Date: 10/11/2018

Simple, just like everyone else here that complained about loss of power. But I had a diagnosis both by autozone and the kia dealer. The diagnosis error code p0717 turbine input shaft speed sensor and wiring harness faulty due to corrosion from moisture getting in from not having adequate sealing or poor quality of rubber seal. Pulling out of stores or my driveway became very damages as you could imagine and I feel the manufacturer should address any and all loss of power issue cause it can result in serious injury or death! I hope you agree and take action to help us all out please.

2 Wiring problem

Failure Date: 02/28/2014

The contact owns a 2014 kia Sorento. The contact stated that while at a complete stop, a strong burning odor emitted inside of the vehicle. The vehicle was maneuvered to the side of the road where the driver exited the vehicle. In addition, small flames ignited from the rear trailer hitch wiring harness and driver's side tail light. The fire department extinguished the fire and disconnected the battery. The contact stated that the failure occurred twenty days after the new trailer hitch was installed. The vehicle was towed to an authorized dealer and had not been repaired. The manufacturer was notified of the problem. The approximate failure mileage was 32,000.




Safety Ratings of Sorento Cars
Fuel Economy of Sorento Vehicles
Sorento Defect Investigations