Steering Tie Rod Assembly problems of the 2007 Mazda CX-7

Two problems related to steering tie rod assembly have been reported for the 2007 Mazda CX-7. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Mazda CX-7 based on all problems reported for the 2007 CX-7.

1 Steering Tie Rod Assembly problem

Failure Date: 03/17/2017

Shortly after purchasing vehicle replaced timing, turbo, exaust, ball joints, tie rod ends & much more. Timing was first, then driving and turbo went out. 2 days ago car sitting in driveway, not running, started smoking from under hood, butst into flames and burnt up. Mazda said no recalls, clearly not true according to website. Almost burnt my house also as it was sitting in driveway and couldnt be moved. If we would have been inside the car, I doubt we would of had time to get pulled over & out as thats how quick it burnt!.

2 Steering Tie Rod Assembly problem

Failure Date: 11/04/2010

2007 Mazda Cx-7. Consumer experienced several problems with vehicle the consumer stated shortly after she purchased the vehicle, she noticed the headlights pointing toward the ground and it took 3-5 trips to the dealer before it was properly fixed. In June 2010, the check engine light illuminated. The dealer diagnosed the problem as an evap system leak which cost $461. 80. In October 2010, during a routine inspection, it was discovered that the vehicle needed an outer tie rod end, in addition to that an alignment was also needed. One week later, the ac compressor failed.


Other Steering related problems of the 2007 Mazda CX-7

Steering problems
16
Steering Tie Rod Assembly problems
2
Steering Is Tight problems
2
Lose Power Steering problems
1


Safety Ratings of CX-7 Cars
Fuel Economy of CX-7 Vehicles
CX-7 Service Bulletins