Brake Light problems of the 2011 Mazda CX-7

Defective taillight assembly: both brake light taillight assembly have melted inside the taillight assembly. Since reporting this to my Mazda dealer I have seen the same problem in other Mazda Cx-7�s. This is a huge safety concern: title transportation part 571�federal motor vehicle safety standards subpart b�federal motor vehicle safety standards �571. 108 standard no. 108; lamps, reflective devices, and associated equipment. S14. 4. 1. 4. 1. 3 where the sample device does not have uniform spectral characteristics in all useful directions, color measurements must be made at as many directions of view as are required to evaluate the color for those directions that apply to the end use of the device. S14. 4. 1. 4. 2. 1 red. The color of light emitted must fall within the following boundaries: y = 0. 33 (yellow boundary); y = 0. 98 − x (purple boundary). The 2017 florida statutes title xxiii motor vehicles; chapter 316 state uniform traffic control; 316. 221 taillamps � (1) every motor vehicle, trailer, semitrailer, and pole trailer, and any other vehicle which is being drawn at the end of a combination of vehicles, shall be equipped with at least two taillamps mounted on the rear, which, when lighted as required in s. 316. 217, shall emit a red light plainly visible from a distance of 1,000 feet to the rear, except that passenger cars and pickup trucks manufactured or assembled prior to January 1, 1972, which were originally equipped with only one taillamp shall have at least one tail lamp. . . It seems that either the Mazda does not want to fix the problem, or my Mazda dealer does not want to take responsibility by replacing the defective taillight assembly. The taillight assembly should either be replaced at no cost or redesigned in a way to stop the melting from occurring. I have reported to this defect to our local Mazda dealer.