general problems of the 2005 Mazda MAZDA3

The contact owns a 2005 Mazda Mazda3. The contact stated that while driving at 65 mph and going over a bump, the rear passenger's side wheel started shaking and making a rattling noise. The contact had to slow down in order to stop the shaking and rattling noise. The vehicle was taking to the dealer and was diagnosed that the tie rod on the rear passenger's side wheel had to be placed. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 129,000. The VIN was not available.

Tires feather or cup in less than 25000 miles due to the rear wheel factory camber tire manufacturers do not recommend aggressive camber and will not warranty the tires for premature failure. Mazda and other manufacturers know that the aggressive camber causes tires to wear faster since they are not designed for this. The feathering drastically affect handling especially in wet weather. Tire manufacturers should state the maximum acceptable camber for their tires and manufacturers should choose appropriately design tires for this application. It is a safety issue since it happens with factory recommended alignment specs. The aggressive camber improves handling but tires are not designed for this. If the tire manufacturer will not back the tire for this application then the car manufacturer has improperly designed the suspension for passenger cars. This is the 3s model with only 135000 miles and 5th set of tires and alignment checked each time.