One problem related to engine stall has been reported for the 2007 Mazda MAZDA3. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Mazda MAZDA3 based on all problems reported for the 2007 MAZDA3.
Tl-the contact owns a 2007 Mazda3. The contact stated that the vehicle failed to start up when the fuel tank was filled the dealer performed a diagnostic which located a failure code at the purge valve was replaced, however the vehicle experienced additional failures the front end vibrated and engine stalled while driving at 65mph the dealer performed a diagnostic which located the engine mount worn and struts leaked the evap system also failed however the valves were replaced. The engine mount and struts and evaporating system was not replaced. The rotor also wore prematurely and could not be resurface. The front bumper clips failed due to defective plastic the clips were replaced several times; however the failure was not corrected. The manufacturer advised the vehicle was not included in NHTSA campaign number 07v295000 (engine and engine cooling). The failure mileage ge was 50,000. Li.