One problem related to brake antilock control unit/module has been reported for the 2008 Mazda MAZDA3. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2008 Mazda MAZDA3 based on all problems reported for the 2008 MAZDA3.
First incident occurred at 25,900 miles; brake warning light appeared on console dash. Dealer identified a failure of the abs (anti-lock brake system) module which was leaking brake fluid. Dealer replaced abs module under warranty. Second occurrence at 37,600 miles; brake, abs, and traction control warning lights appeared on dash. Dealer identified failure of the abs module which had stopped communicating with the pcm. As a result of this second failure, the abs and/or traction control system was not functioning normally. Dealer could not identify a root cause for the consecutive failures of the abs module. Cost to replace the abs module was quoted by dealer at approximately $1,600. 00 (part + labor). Updated portable 02/24/11.
| Service Brakes problems | |
| Brakes Failed problems | |
| Abs Brake Fail problems | |
| Brake Disc Pads problems | |
| Brake Light On problems | |
| Brake Fluid Leak problems | |
| Brake Antilock Control Unit/module problems | |
| Brake Master Cylinder problems |