Five problems related to suspension have been reported for the 2012 Mazda MAZDA3. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Mazda MAZDA3 based on all problems reported for the 2012 MAZDA3.
My wife was driving her vehicle and the front cv axle completely snapped in half. Still not sure what could have possibly occured being there is no accident report on this vehicle. Perhaps the part was corroded or faulty.
The rear shocks have an upper attachment that is made out of aluminum. After only 49000 miles the shock mount corroded and broke. It also caused the shock rod to bend.
After a mechanics check it was found: 1) slight feathering/edgewear/cupping on all tire's and 2) power steering warning light on ign on however clears on engine start. This is all despite full maintenance history as per Mazda guidelines. The problem causes significant tire noise when driving. Although tire thread on the vehicle is at 87%, it was recommended to replace all four tires at time of inspection. Wheel alignment shows the vehicle is within factory guidelines for the vehicle. Possible issue could be flaws in shock/strut manufacturing as the vehicle is well within replacement timeframe for these parts.
Premature tire cupping of rear tires. All tires rotated according to Mazda maintenance schedule. Result in tire road noise, uneven wear, early replacement. Rear camber setting is possible issue.
Purchased as certified preowned from local Mazda dealer. Premature tire cupping of rear tires. Result in tire road noise, uneven wear, early replacement. Rear camber setting is possible issue expressed "unofficially" by Mazda mechanic.
| Suspension problems | |
| Sway Bar problems | |
| Suspension Noise problems |