general problems of the 2018 Mazda MAZDA3

What component or system failed or malfunctioned, and is it available for inspection upon request? the high-pressure fuel pump failed. This component failure prevents the car from starting or staying running. The check engine code confirmed the high-pressure fuel pump failure. The failed component is currently at the Mazda dealership and is available for inspection upon request. How was your safety or the safety of others put at risk the car suddenly stalled while driving on the roadway, creating a dangerous situation. If this had happened on the freeway or in fast-moving traffic, it could have led to a serious accident. Losing power and control of the vehicle at higher speeds poses a major safety risk to both the driver and surrounding vehicles. I was fortunate that the failure occurred on a city street rather than on the freeway. Has the problem been reproduced or confirmed by a dealer or independent service center? yes. The Mazda dealership inspected the vehicle and confirmed that the high-pressure fuel pump had failed, which was also verified by the check engine code. This failure caused the stalling and starting issues. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives, or others? the vehicle was inspected by an authorized Mazda dealership, which diagnosed and confirmed the high-pressure fuel pump failure. It has not been inspected by police or insurance representatives. Were there any warning lamps, messages, or other symptoms of the problem prior to the failure, and when did they first appear? before the final failure, the car was hesitant to start, and after it stalled, the check engine light appeared. There were no prior warning messages or signs before the car suddenly stalled while driving. Additional details: the car is only seven years old with approximately 52,000 miles, and it is concerning that such a critical component would fail this early.

I was driving on the highway in sixth gear and went to down shift to get on to the off ramp and was unable to get it out of sixth gear. I had it towed to the dealer where they were going to charge 4 grand just to tear down the transmission to tell me what might be wrong. So I towed it home and once I was able to get the transmission open, I found the roll pin that connects the shifting shaft to the shift selector plate had worked itself out. If the transmission had been in neutral, it would have taken less than 20 minutes to fix. But, because it was stuck in gear the whole transmission had to be taken apart.

The contact owns a 2018 Mazda Mazda3. The contact stated while driving 25 mph, the vehicle stalled inadvertently. The contact was unaware if there were any warning lights illuminated. The contact was able to veer to the side of the road; however, the vehicle failed to restart. The contact's husband added fuel to the vehicle; however, the failure persisted. The contact stated that the vehicle restarted 15 minutes later. The vehicle was taken to an unknown dealer who informed the contact that the failure could not be duplicated because there was no warning light illuminated. The vehicle was not diagnosed or repaired, and the failure persisted. The contact stated that the failure reoccurred upon shifting from reverse(r) to drive (d). The power train warning light and several unknown waring lights were illuminated. The contact was able to restart the vehicle and continued driving. The manufacturer was not notified of the failure. The failure mileage was approximately 32,000.