general problems of the 2008 Mazda MAZDA6

One problem related to engine and engine cooling has been reported for the 2008 Mazda MAZDA6. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2008 Mazda MAZDA6 based on all problems reported for the 2008 MAZDA6.

1 Engine And Engine Cooling problem

Failure Date: 12/12/2012

I was going down the I-90 in new york. I just got off a exit and notice my clutch was slipping so I stop and check my slave cylinder and it was cover in oil. I proceed to my destination and park I got out and look some more and notice oil running out of my bell housing. Had it towed to a garage and check out they told me the rear main seal is gone and need to be replace. They also told me that the crankshaft had a lot of play in it side to side I also google this problem more than one person has this problem with low miles.


Other Engine And Engine Cooling related problems of the 2008 Mazda MAZDA6

Engine problems
1
Loud Engine Noise problems
1
Engine And Engine Cooling problems
1


Safety Ratings of MAZDA6 Cars
MAZDA6 Service Bulletins
MAZDA6 Safety Recalls
MAZDA6 Defect Investigations