Seat Belt Problems of Mazda MPV

The drivers seatbelt clasp or buckle refuses to accept the steel tab, and will not lock.

See all problems of the 2002 Mazda MPV 🔎.

Bolt holding the driver side seat belt latch snapped in two and left the latch hanging free.

See all problems of the 1998 Mazda MPV 🔎.

- the contact was driving a Mazda Mpv with an odometer reading of 75000 miles, in foggy conditions on a two lane highway, her vehicle was hit from behind causing her to hit the vehicle in front of her. The contact stated that the traffic had stopped, and she was slowing down. At the time of the impact, the vehicle was traveling at approximately 20 mph. The second vehicle behind her did not stop and struck her vehicle at approximately 40 mph, according to the police. The airbags did not deploy. The seat belt failed and the front passenger was injured. There were a total of three passengers in the vehicle, all of the passengers were belted and all sustained minor injuries. The vehicle sustained both front & rear end damage and had to be towed away. The contact has a police report and pictures of the vehicle.

See all problems of the 2003 Mazda MPV 🔎.

Child's neck somehow got caught up in the seat belt and would not release. Please provide any further information. Ph.

Consumer stated that when putting on the rear seat belt it would not be tight enough for it to fit the consumer properly. Dealer will be notified. Ts.

See all problems of the 2000 Mazda MPV 🔎.

Foia request a full copy of NHTSA bulletin 0800102, NHTSA item 634469 re seat belt comfort in a 2000 Mazda Mpv. (nar).

Consumer states while vehicle was parked with the emergency parking brake on, the vehicle started to move forward. The gear shift would stick in park or move by itself, the right rear door would open while the vehicle was in motion and failed to close properly, and one of the seat belts was installed backwards.