One problem related to front suspension control arm has been reported for the 2003 Mazda Protege. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2003 Mazda Protege based on all problems reported for the 2003 Protege.
I bought the car from a smaller cheap dealership, I had no idea that the front end would be as bad as it got. My lower control arm / ball joint was so corroded every time I made a left turn it would make a loud noise in the left front wheel then would continue to happen over and over each time. This would happen often when it was dry and warm and sat for awhile. Living in buffalo, well you can not help but hit potholes in some places more than others. This would make the problem worse and throw my steering off while travel at a high rate of speed. If I was doing the curves on route 33 or route 290 I would have to slow done to maintain steering ability. I have recently been told it was so bad I could lose my wheel and crash. So I went to a local repair shop and they fixed the problem; but with a slightly new problem one of the screws were so corroded they charged me $100. 00 to make an access panel from my drivers side floor panel under my feet. The the total for just those parts came to $350. 00 plus wheel alignment.