Engine Oil Leaking problems of the 2006 Mazda RX8

My vehicle experienced a defect known to Mazda to the extent of them issuing a recall (or ssp) in the canadian market due to use of corrosives and excessive wet seasons causing build up on and corrosion of the oil cooler lines. Mazda clearly stated in the canadian ssp (#76) that extensive corrosion could cause a leak and/or loss of pressure, and knowing that a loss of pressure or a significant amount of oil while the car was in operation would cause drastic mechanical engine failure by way of burning out the seals/rotors/bearings and eventual seizure or total loss of compression in the motor. The loss of oil pressure due to corrosion directly resulting from this caused my apex seals to overheat and no longer provide a seal to allow the motor to hold compression. Due to this failure directly caused by the known defect, and the fact that the issue was put in place for canada due to their high propensity for extended wet seasons and high use of corrosives to alleviate wintery conditions on the roadways, Mazda should also have issued regional or case-by-case recalls of vehicles that experience this same defect in areas of the united states that experience similar conditions. Had I been travelling on the highway and not on a 25mph city road, I could have experience a major accident or incident because of my motor failure. There are numerous other cases of this defect showing in american vehicles across the country, from near me (in new england) to California that have been reported online. I can contact the licensed mechnic who dealt with the vehicle for copies of his work orders, and I have receipts to prove that I purchased oil cooler lines as replacements before I knew of the loss of compression and ruined motor. Mazda USA was of no help in alleviating the problem, and I am now out thousands of dollars on a vehicle that I had recently purchased before the event occurred.