Automatic Transmission Torque Converter problems of the 2004 Mercedes Benz CLK500

One problem related to automatic transmission torque converter has been reported for the 2004 Mercedes Benz CLK500. The most recently reported issues are listed below.

1 Automatic Transmission Torque Converter problem

Failure Date: 10/01/2010

I was driving on a busy street when the Mercedes Benz started jerking. After stopping at a red light, I could not get the car to accelerate past 2nd gear; thus, I was driving on a street with a 45 mph speed limit at less than 20 mph. Then, as I was crossing an intersection, the car finally stalled. Luckily, because it was an intersection, the oncoming cars maneuvered around me. After turning the ignition, it started up again, and I was able to drive it into a parking lot (once again, not past 2nd gear). I towed the vehicle to the dealership, and they have informed me that the radiator leaked fluid into the transmission; as a result, the transmission, the transmission control unit, and the torque converter are all damaged and needs replacement. I believe that the fault lies on mercedes to replace the damaged parts due to their knowledge that there was a potentially faulty radiator installed in their vehicles. It is dangerous to drive on a busy street or highway only to have the car suddenly stop operating. I had no idea that there was potentially something wrong with the car until this incident. I have researched this issue since the incident and have discovered that this has happened to numerous people. Please help us.




CLK500 Service Bulletins
CLK500 Defect Investigations