Table 1 shows one common service brakes related problems of the 2018 Mercedes Benz Metris.
| Problem Category | Number of Problems |
|---|---|
| Service Brakes problems |
The contact owns a 2018 mercedes-benz Metris. The contact stated the vehicle had displayed that there were failures with several safety features. The instrument panel had failed to display any information regarding any safety features. The vehicle had been taken to the dealer who had diagnosed that the brake sensors had failed. The brake sensors had been replaced. Approximately, seven months after having the vehicle repaired the instrument panel displayed failed safety features again. The instrument panel also failed to display any information regarding the safety features of the vehicle. The dealer was informed of the failure; however, the vehicle had not been taken to the dealer to be diagnosed or repaired. The manufacturer was informed of the failure and referred the contact to the dealer. The failure mileage was 10,000. The VIN was unavailable.
Wheel speed sensors appear to fail on a routine basis (every 0-10 months), similar to the subject of recall 21v-042 on sprinter vans. Sensor failure disables most safety features of vehicles including abs, blind spot warning, assisted steering, and other safety features. The failure causes notable issues with handling/steering and braking. Failure at highway speed impacts vehicle driving stability and increases the risk of a crash. Dealer previously repaired under warranty in October or November 2021. Unit failed in traffic at highway speed again in September 2022. Contacted dealer and was informed they are not scheduling maintenance appointments at this time and would not reimburse the cost of repair by an outside mechanic. They would also not acknowledge whether the vehicle is safe to drive and would not give an estimate on when they would be able to schedule a service appointment. They recommended transporting the vehicle to another city for service but implied they would not reimburse costs of doing so. Having most safety systems dependent on a poorly designed part with a high failure rate is not acceptable.