Steering Tie Rod Assembly problems of the 1999 Mercury Sable

Three problems related to steering tie rod assembly have been reported for the 1999 Mercury Sable. The most recently reported issues are listed below.

1 Steering Tie Rod Assembly problem

Failure Date: 08/09/2004

While driving steering wheel feels real loose, nd makes a loud noise. Dealer replaced the tie rod at consumer's expense of $200.

2 Steering Tie Rod Assembly problem

Failure Date: 06/12/2002

Problems with abs. The vehicle was in two accidents due to the inability to control the vehicle during normal driving conditions, where the abs did not work. The vehicle was in for repair 7 times. The following are repairs and or problems the vehicle experienced: torque converter replaced after transmission fluid was found low, exhaust leak fixed, washer fluid would spray when the turn signal and lights were on, shaking when the brakes were applied/resurfaced rotors, trunk leaked water, replaced multi-function switch to fix washer fluid problem, abs not working when there was a panic stop, left and right spindle assembly was replaced, front end rotors were replaced again, wheel alignment, the abs did not engage and caused an accident, and replaced left side outer tie rod end.

3 Steering Tie Rod Assembly problem

Failure Date: 10/20/1999

Consumer was driving 30 - 35 mph tie rod popped out, disabling steering making vehicle go out of control. Consumer almost had an accident. Consumer was driving under normal weather conditions.




Fuel Economy of Sable Vehicles
Sable Service Bulletins
Sable Safety Recalls
Sable Defect Investigations