Wiper Problems of Mitsubishi Endeavor

This vehicle has a potential manufacturer defect in the rear window regarding the defroster. After repeated use of the defroster heating up the window and cooling down the elements in the glass contracted and expanded and shattered the back window spontaneously causing an over $600 repair. There was no prior damage and no other possible causation that occurred for this and the vehicle window repair specialist looked at it and determined to that the fracture line was caused by these elements embedded in the glass this needs to be investigated.

See all problems of the 2011 Mitsubishi Endeavor 🔎.

Windshield randomly fogs over. Heat switches randomly between heat and ac. Gas pedal sticks even when applying pressure to brakes car acts like the gas pedal is floored. Car lunges forward even when brakes are applied. Vehicle can be stationary and still lunges also has happened when it's in motion has happened in city and and rural areas.

See all problems of the 2006 Mitsubishi Endeavor 🔎.

The window regulators on both passenger front and rear and driver front and rear windows failed to work, the windows fell down while driving and I have to use zip ties to hold the windows up.

See all problems of the 2004 Mitsubishi Endeavor 🔎.

The contact owns a 2011 Mitsubishi Endeavor. While driving various speeds, the defrost failed to operate. A local dealer was not contacted. The vehicle was taken to an independent mechanic who diagnosed that the hvac control module needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The VIN and failure mileage were unknown.

Like many, many reports the drivers side floor mat is saturated and pooled with water from the ac/hvac system drainage failure. The manufacture has TSB's on on the issue with foam gasket replacement or initially drilling a hole cleaning it out and installing a rubber plug TSB-08-55-007. Now installation of a hose used for radiator overflow on an eclipse now being suggested TSB-11-55-003. How is this not a design flaw and how is the mold and moisture issue not a safety concern. The internal cab parts are not coated or treated to inhibit rust from this excessive moisture. The excessive moisture inside the vehicle also accumulates on the inside windshield of the vehicle as it removed thru the system but re-enters thru the firewall into the floor.

The contact owns a 2004 Mitsubishi Endeavor. The contact stated that the front and rear passenger side window regulators failed upon activation. The malfunction caused the window glass to release down into the door panel. The failure recurred on separate occasions. The vehicle was taken to an auto glass specialty shop each time for the window regulator replacement. The manufacturer was not notified of the problem. The approximate failure mileage was 97,000.