Brake Abs Warning Light problems of the 2010 Mitsubishi Lancer

My abs and asc lights have been on for a while. Took it to a mechanic and was told it wasnt a problem, just a faulty electrical system. One day, I was coming off an exit ramp trying to brake so I could turn but my brakes wouldnt engage so I slam on my brake and they locked up and my car slid and crashed into a median. Tired to steer away but it wouldnt turn.

My complaint is on the anti lock brake pump/motor on 2010 Mitsubishi Lancers. Iv read alot and talked to alot of people about this issue where at anytime the car ends up having a low or bad battery, and or any other issues causing lower then normal voltage. It sends a code to the abs module causing it to fail. Making your abs and engine light come on the dash. With that failure it stores the code and even after the electrical problems are fix you still can not clear the abs/brake code. The only fix to get ride of the lights and to get your abs pump/motor working again is to replace it with a brand new unit costing almost $3,000 dollars to Mitsubishi. Hearing from other people with this issue, it is a defect from Mitsubishi. This problem occured to me when my car was is park running, but have seen it happen to other people just driving down the road or highway ( in motion & stationary ) also with out this fix you cant not get your vehical passed in a state inspection.

Drove out of my driveway and within 5 seconds abs malfunction light came on as well as stability control. After further investigation I found that the drivers side rear abs sensor was faulty due to the sensor not being sealed correctly by the manufacturer which led to corrosion and the sensor failing. Mitsubishi would not warranty this item even though its known to be faulty, Mitsubishi even has a new part number for the sensor. This should obviously be a safety recall.