Eight problems related to steering have been reported for the 2004 Nissan Altima. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2004 Nissan Altima based on all problems reported for the 2004 Altima.
Its an accident waiting to happed, its hard to turn the steering wheel left or right,even when changing lane at low speed like 20 mph,it required effort to turn the steering wheel,the binding forces was intermittent at certain steering wheel position,nissian should recall this(48080-8j000 lower steering u_joint),before someone have a deadly accident.
Found out that the sub-frame assembly panels (front floor panels) are rotting out. Issue is if they fail cars tires will tilt in as the suspension is tide into the front floor panels.
The power steering last week has started to tighten up in places. While turning the wheel, there is a hard spot that the wheel seems to get "stuck" or "catch" at. I took it into a mechanic and he informed me that the steering rack would most likely need to be replaced. I did more research about this problem and it seems to be a common issue in Nissan Altima vehicles. The mechanic also told me his 2003 Altima had to have the same repair last year about this time.
Description/issue: my 2004 Nissan Altimas steering is very stiff and hard to turn. I would like avoid any loss of steering control and prevent any risk of crashing. I will get this fix immediately but wanted to officially report this. I did some searching online and found others who own Altimas have reported and found very similar issues with very tight steering. Please help investigate if Nissan Altimas have steering defects traveling at low speeds? please help investigate if there is a mandatory recall by the manufacturer. Please note - I have confirmed Nissan frontier models have already started the recall. The Altima problem I have described above is the same. Sincerely, concerned Altima consumer.
I have a 2004 Nissan Altima 2. 5s, I have been having steering problems and have had 3 mechanics look at it and cannot figure out what is wrong with the steering. When I take turns it is really tight, I have to pull the steering wheel back myself. I tried emailing Nissan of north America, they did not respond, there should be a recall for this problem many people have this problem from what I reading online. There has to be a way to fix this problem, please help me find a way. I would greatly appreciate any help you can provide. There is also a creeking sound on the left side in the front of the car that started at the same time as the steering problem. This steering problem occurs when it is cold outside. I have had the sway bar links cleaned thinking it was that , but that did not work a few mechanics including a Nissan mechanic cannot figure out what is wrong.
The vehicle makes a clunking sound and power steering ?sticks? when turning the wheel. Though no accidents, there have been near misses due to me not being able to turn on time. This problem is extremely dangerous and should be recalled.
A defective steering universal assembly. Occurred suddenly. I could barely steer the car. Very dangerous . Thank goodness it happened in my neighborhood and not on the highway. 58,000 miles on the car. I wrote Nissan canada about the problem and they contacted me by telephone. I was told that Nissan didn't consider it a problem, the repair cost me $539. 00. It's not the repair cost that is important, it's the danger to the public; not only to the driver of the vehicle, but to third parties. I have since l,earned of the same problem with a 2005 Nissan Altima. It is just about impossible to steer the vehicle when the steering wheel assembly is defective.
Problem vehicle is 2004 Nissan Altima with 80,000 miles. Noticed when pulling out of driveway after car had sit overnight in garage that steering wheel was binding when I tried to turn the vehicle. During the course of the drive the steering wheel would bind both during turning and when returning to straight. The binding caused extra effort (requiring both hands) to turn the steering wheel and also required extra effort to return the wheels to straight because the binding prevented the wheels from returning to straight on their own. The binding was bad enough that it could have caused an accident because of the effort required to turn the wheel and the difficulty in straightening the wheels to stop turning. The binding force was intermittent and seemed to be related to certain places in the orientation of the wheel. After research on the internet I discovered that many other people have had this problem with similar year and model of car and they all referenced the lower universal joint in the steering linkage as the problem part (Nissan part 48080-8j000). When I removed the part it was rusty and extremely tight (I will hold onto the old part in case anyone wants to see it or use it as evidence). The replacement part was back ordered by Nissan when I ordered it from the dealer. The dealer said that they have been selling lots of this part and the part has been taking a few days to two weeks to arrive due to high demand. Clearly there is a problem with the design of this part. When I finally got the new part (48080-8j000 lower steering u-joint) and installed it the steering worked smoothly again.