Four problems related to car stall have been reported for the 2007 Nissan Maxima. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Nissan Maxima based on all problems reported for the 2007 Maxima.
Tl-the contact owns a 2007 Nissan Maxima. The contact stated while driving approximately 35 mph, the vehicle stalled intermittently without warning. After several attempts the vehicle restated. The failure recurred twice. The vehicle was taken to a dealer where it was diagnosed that the crankshaft sensor failed. The vehicle was repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 60,000. Ak.
This Friday October 24th I was driving back home in my 2007 Maxima se (VIN: 1n4ba41e07c844349) when suddenly my car stalled while driving with no control over the steering wheel. Luckily I was at the entrance of my subdivision minute after taking exit from a 50 mph state route. My car ran over the curb barely missing a rare collision with a SUV whose driver had no clue what's going on with my car. I can't even imagine what could have happened if the car stalled on 50 mph state route during the rush hour. The problem turned out to be a faulty cam shaft sensor that I've ordered and will be arriving in a day or two. Regardless of the faulty part I believe the car behavior is unacceptable as a result of that. I did spent time researching about this problem online and it looks I'm not the only one as there are many Nissan owners with this problem and have their own horror stories to tell. I guess I'm extremely lucky that I'm writing this email in person vs. Someone else doing it for me. It's extremely hard for me to believe that the car would stall due to a faulty issue and I'm sure Nissan is aware of this problem but there is still no recall. I urge Nissan to consider this issue seriously and make remedy available as soon as possible before its too late.
The contact owns a 2007 Nissan Maxima. The contact stated that while driving 30 mph, the vehicle stalled as all of the lights on the instrument panel illuminated. The vehicle was taken to the dealer. The technician diagnosed that the cam shaft sensor was defective and needed to be replaced. The manufacturer was made aware of the failure. The vehicle was repaired. The failure mileage was 59,631 and the current mileage was 59,800.
My new 2007 Nissan Maxima was "bucking" at 40 mph & 60 mph. The service engine soon came on. Later that day, the vehicle stalled out on me 3 times. The next day I was able to drive the vehicle to the dealership. They indicated that it was the cam shaft. The next day I was able to pick up my vehicle. However, I couldn't get it out of the dealership parking lot after stalling 3 times each time I put it into drive. The mechanic was authorized to take my vehicle over night to drive it after being able to test drive it. I was informed the next day that the mechanic couldn't get it out of the dealership parking lot either. They have been in touch with the manufacturer, but they can't seem to locate any error.