general problems of the 2005 Nissan Murano

Takata recall. . I drove my 2005 Nissan Murano and I parked the Nissan. 20 minutes later started to back the car and as soon as I put it on dr it went by 2 miles an hour so then I pressed on the gas all the way down and it still went to miles an hour it's still drove but it was going around 5 miles an hour. Then I parked the Nissan and let it cool off and see what was wrong. I could not find nothing, I called my husband he could not find nothing either, he drove it around the block and it still went 5 miles an hour so then he checked the engine nothing was wrong but it did say abs and then around 20 minutes later the Nissan turn on and it went normal and nothing happened until 2 months later. The next time I was at a drive-thru and then all of a sudden the abs turn on and it did not want to go fast it went again five miles an hour. Then I turn around the corner and then it went fast but then it went slow again so I park the Nissan, and begin to start it and then it wouldn't start the abs went on again, then the battery was dead. I finally got a jump and it turned back on like normal and it went normal until I got to the store and I left the Nissan on with the air condition and had my son in the car. My son said that air conditioner keep going on and off on and off the windows were not working try to roll down the windows it wasn't working so then I got in the car and as soon as I put it in dry it didn't want to go it went 5 miles an hour then the abs turned back on and then it went back to normal I was driving I made it all the way home and that is what's going on with a Nissan Murano.

The contact owns a 2005 Nissan Murano. While driving approximately 50 mph, the vehicle slowed down and the brake and battery indicators illuminated. The failure was not diagnosed. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was approximately 34,000.

The contact owns a 2005 Nissan Murano. The contact stated that while driving 25 mph, the brake pedal was abnormally depressed into the floorboard. The failure caused an increase in stopping distance and time. The contact shut off the vehicle and once restarted, the failure was reset. The vehicle was taken to the dealer who was unable to diagnose the failure. The manufacture was also contacted and advised the contact to take the vehicle back to the dealer for further inspection. The failure mileage was 60,000 and the current mileage was 63,000.

: the contact stated while applying brake pressure at 20mph or less, there was increased stopping distance. The vehicle was taken to the dealer where diagnostic test where performed. There where no failure codes detected. The service manager also, test drove the vehicle, but could not duplicate the problem.