Power Window Problems of Oldsmobile Cutlass

Oldsmobile Cutlass owners have reported 2 problems related to power window (under the visibility category). The most recently reported issues are listed below.

1 Power Window problem of the 1997 Oldsmobile Cutlass

Failure Date: 02/01/1999

Description of problems- drivers side rear window replaced at delivery due to large scratch. Tail light cover replaced due to moisture build up. Drivers and passengers window motors replaced due to malfunction. Ball joints replaced at 2000 miles, cv joints replaced at 1000 miles, control arms replaced once at 5800 miles and again at 10000 miles. Steering rack replaced at 12400 miles, by this time the complete front end had been replaced from the factory original. And at 19000 miles it is making noise again.

See all problems of the 1997 Oldsmobile Cutlass 🔎.

2 Power Window problem of the 1997 Oldsmobile Cutlass

Failure Date: 09/01/1998

Abs light has been coming on intermittently, braking distance is normal. Vehicle taken to dealer 15-20 times. Replaced brake pads/ alternator/ battery/ wiring harness, and put in sensor. Did not remedy problem, vehicle at dealer at this time. Serpentine and tensioner belt broken. Security light blinks due to bad theft lock sensor assembly . Blower speeds inoperative. A/c control inoperative. Left front seat belt buckle falls to floor. Power window inoperable due to electrical switch failure.


Other Common Visibility related problems of Oldsmobile Cutlass



Fuel Economy of Cutlass Vehicles
Cutlass Service Bulletins
Cutlass Safety Recalls
Cutlass Defect Investigations