Plymouth Prowler owners have reported 1 problem related to steering rack (under the steering category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Plymouth Prowler based on all problems reported for the Prowler.
1st. Thing I noticed a couple of months ago was the steering of the car was getting harder and harder to control, and I was hearing cracking and popping noises comming from the front end but I nor anyone else who also heard the noises could tell just where they were comming from , and I own a car lift but evan after many many inspections I could never see anything wrong or out of place , I was told that my steering rack was making a lot of noise so I had and alinement done and was told that I did have ( something wrong ) but they did not no what it was either , so after discussing this with my dealer on 8-7-02 and making an appointment for a new steering rack to be installed on 8-19 -02 , but on 8-8-02 at 7:50 am and driving over a bridge on north 14th. Street the left lower ball joint came appart and let the left front wheel and tire assy. Fly off but still attatched from the upper ball joint and brake line but bouncing vilently against the ground and body untill I could quit sliding down the bridge and stear the car around the corner and off of the main street , I called my dealer and later requested that the stresses upper ball joint be replace as well as the right lower ball joint but was told they would not do that , I am very worried that what happened on the left side will soon happen on the right side and I dont want to go through this again , I was only going 35 mph and driving in town but what would happen on the interstate at 75 mph , I now think of it as a ticking time bomb ready to go off at any time and the driving experiance wont be the same anymore .
See
all problems of the 1999 Plymouth Prowler
🔎.
| Problem Category | Number of Problems |
|---|---|
| Steering Rack problems | |
| Steering problems | |
| Steering Knuckle Spindle problems |