All vehicles » International Harvester » 2674

Safety Recalls of International Harvester 2674 Vehicles

There have been 2 safety recalls for the International Harvester 2674. The most recent recalls are shown below. Table 1 and Table 2 show the historical recalls and the recall statistics by the model year of the International Harvester 2674.

NHTSA Recall #: 96V233002; Nov. 22, 1996

This locking tab prevents the wheel bearing nut from loosening during vehicle operation. If this tab is deformed, the nut can loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.

Recalled Vehicles: 1996 International Harvester 2574, 1997 International Harvester 2574, 1997 International Harvester 2654, 1997 International Harvester 2674, 1997 International Harvester 4700, 1997 International Harvester 4800, 1997 International Harvester 4900, 1997 International Harvester 5000, 1997 International Harvester 8100, 1997 International Harvester 8200, 1997 International Harvester 9200, 1997 International Harvester 9300, 1997 International Harvester 9400, 1997 International Harvester 9800

Component: SUSPENSION:REAR

Recall Summary: The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted.... Details of this recall 🔎

NHTSA Recall #: 94V196000; Oct. 7, 1994

This can cause loss of speed control, driver distraction, and result in an accident.

Recalled Vehicles: 1994 International Harvester 2574, 1995 International Harvester 2574, 1994 International Harvester 2674, 1995 International Harvester 2674, 1994 International Harvester 3600, 1995 International Harvester 3600, 1994 International Harvester 4700, 1995 International Harvester 4700, 1994 International Harvester 8100, 1995 International Harvester 8100, 1994 International Harvester 8200, 1995 International Harvester 8200

Component: VEHICLE SPEED CONTROL:ACCELERATOR PEDAL

Recall Summary: The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the mounting pads on the base of the pedal ... Details of this recall 🔎

Table 1. Historical Recalls of International Harvester 2674 Vehicles

Date	Component	Vehicle Affected
Nov. 22, 1996	Suspension:rear	1,133
Oct. 7, 1994	Vehicle Speed Control:accelerator Pedal	6,449

Table 2. Recall Statistics of International Harvester 2674 Model Years

Model	# Recalls
1997 International Harvester 2674	1
1995 International Harvester 2674	1
1994 International Harvester 2674	1