There has been 1 safety recall for the Isuzu W-7. The most recent recalls are shown below. Table 1 and Table 2 show the historical recalls and the recall statistics by the model year of the Isuzu W-7.
If the bearing siezed, the axle hub would be noisy atbest, and in the worst case, the axle shaft could fall out causing loss ofvehicle control which may result in an accident.
| Recalled Vehicles: 1991 Isuzu FTR, 1991 Isuzu W-7 |
| Component: POWER TRAIN:AXLE ASSEMBLY:AXLE SHAFT |
| Recall Summary: Bearings used in the rear axle hubs on these vehicles are improperly machined; bearing could seize at low mileages before sufficient run in is achieved. ... Details of this recall 🔎 |
| Date | Component | Vehicle Affected |
|---|---|---|
| Feb. 15, 1991 | Power Train:axle Assembly:axle Shaft | 324 |