There have been 4 safety recalls for the Nissan 200SX. The most recent recalls are shown below. Table 1 and Table 2 show the historical recalls and the recall statistics by the model year of the Nissan 200SX.
This can result in gradual wear over a period of time inside the joint that could lead to the separation of the wiper linkage assembly from the wiper motor linkage at the ball joint. A loss of windshield wiper function can result in this separation occurs.
| Recalled Vehicles: 1995 Nissan 200SX, 1996 Nissan 200SX, 1997 Nissan 200SX, 1998 Nissan 200SX, 1995 Nissan Sentra, 1996 Nissan Sentra, 1997 Nissan Sentra, 1998 Nissan Sentra |
| Component: VISIBILITY:WINDSHIELD WIPER/WASHER:LINKAGES |
| Recall Summary: Vehicle description: passenger vehicles. Water can enter and displace the grease in the wiper arm linkage ball joint where the wiper linkage attaches to the wiper motor linkage. ... Details of this recall 🔎 |
The safety belts would not provide adequate protection to an occupant in a vehicle crash.
| Recalled Vehicles: 1990 Infiniti M30, 1991 Infiniti M30, 1990 Infiniti Q45, 1991 Infiniti Q45, 1987 Nissan 200SX, 1988 Nissan 200SX, 1989 Nissan 240SX, 1990 Nissan 240SX, 1991 Nissan 240SX, 1991 Nissan D21, 1988 Nissan Pathfinder, 1989 Nissan Pathfinder, 1990 Nissan Pathfinder, 1991 Nissan Pathfinder, 1987 Nissan Sentra, 1988 Nissan Sentra, 1989 Nissan Sentra, 1990 Nissan Sentra, 1991 Nissan Sentra, 1988 Nissan Truck, 1989 Nissan Truck, 1990 Nissan Truck, 1987 Nissan VAN, 1988 Nissan VAN, 1989 Nissan VAN, 1990 Nissan VAN |
| Component: SEAT BELTS:FRONT:BUCKLE ASSEMBLY |
| Recall Summary: The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press. " if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly. ... Details of this recall 🔎 |
This condition can cause increased brake pedal travel and stopping distances.
| Recalled Vehicles: 1995 Nissan 200SX, 1995 Nissan Sentra |
| Component: SERVICE BRAKES, HYDRAULIC:ANTILOCK |
| Recall Summary: The anti-lock braking system (abs) hydraulic actuator was not properly purged of all air during the fill and evacuation process causing air bubbles to get into the brake system. ... Details of this recall 🔎 |
| Recalled Vehicles: 1980 Nissan 200SX |
| Component: VEHICLE SPEED CONTROL |
| Recall Summary: Moisture present in the exhaust gas recirculation system may, under conditions of sub-zero temperatures and low egr flow rate, condense and freeze in the throttle chamber. An icing condition could occur if the vehicle owner fails to adequately warm up the engine before driving.... Details of this recall 🔎 |
| Date | Component | Vehicle Affected |
|---|---|---|
| May. 5, 1998 | Visibility:windshield Wiper/washer:linkages | 512,387 |
| May. 24, 1995 | Seat Belts:front:buckle Assembly | 2,730,462 |
| Mar. 1, 1995 | Service Brakes, Hydraulic:antilock | 950 |
| Aug. 28, 1980 | Vehicle Speed Control | 39,382 |
| Model | # Recalls |
|---|---|
| 1998 Nissan 200SX | 1 |
| 1997 Nissan 200SX | 1 |
| 1996 Nissan 200SX | 1 |
| 1995 Nissan 200SX | 2 |
| 1988 Nissan 200SX | 1 |
| 1987 Nissan 200SX | 1 |
| 1980 Nissan 200SX | 1 |