Structure Problems of SAAB 95

SAAB 95 owners have reported 3 problems related to structure (under the structure category). The most recently reported issues are listed below.

1 Structure problem of the 1999 SAAB 95

Failure Date: 06/01/2008

Defective dashboard sid.

See all problems of the 1999 SAAB 95 🔎.

2 Structure problem of the 2002 SAAB 95

Failure Date: 06/10/2004

Contact stated the inboard dashboard side information display panel garbled, and there was no legible display printing off. The dealer advised the contact this was a frequent problem, and he would have to replace it often. He had the system repaired previously ,and was experiencing the problem again. The manufacturer will offer no free remedy.

See all problems of the 2002 SAAB 95 🔎.

3 Structure problem of the 2003 SAAB 95

Failure Date: 10/15/2003

The vehicle stalled on 4 separate occasions from various speeds of 25 mph or more while driving. The vehicle has been to the dealer on 3 separate occasions. The dealer has cleaned and tightened the battery cables, the first time, they replaced the crank sensor, t-7 and the ignition switch, the second time and the third time, they were unable to duplicate the problem. The ecm was replaced but the vehicle stalled again, the cup holder crack and had broken, the battery cables were loose and dirty, the transmission did not shift properly and caused a jerking motion, the electrical gauges dropped and the vehicle lost acceleration.

See all problems of the 2003 SAAB 95 🔎.


Other Common Structure related problems of SAAB 95



95 Service Bulletins
95 Safety Recalls
95 Defect Investigations