Accelerator Pedal problems of the 2006 Subaru Outback

Three problems related to accelerator pedal have been reported for the 2006 Subaru Outback. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2006 Subaru Outback based on all problems reported for the 2006 Outback.

1 Accelerator Pedal problem

Failure Date: 01/12/2018

Tl the contact owns a 2006 Subaru Outback. While driving at 35 mph, the contact attempted to depress the accelerator pedal however, the pedal remained in the upright position. The vehicle shifted into limp mode. The check engine warning light was illuminated. The contact pulled over, turned off and restarted the vehicle. The vehicle was driven to the residence. The failure recurred several times. The vehicle was not taken to be diagnosed nor repaired. Neither a dealer nor the manufacturer were notified of the failure. The failure mileage was 160,000.

2 Accelerator Pedal problem

Failure Date: 01/14/2016

The contact owns a 2006 Subaru Outback. While driving various speeds, the check engine indicator illuminated and the cruise control warning indicator began to flash. As a result, the contact mentioned that the vehicle failed to accelerate. The vehicle was taken to the dealer where it was diagnosed that the accelerator pedal failed and needed to be replaced. In addition, the accelerator position sensor and the epm were also replaced. The failure recurred. The manufacturer was made aware of the failures. The approximate failure mileage was 77,000.

3 Accelerator Pedal problem

Failure Date: 12/18/2010

The contact owns a 2006 Subaru Outback. The contact was driving 55 mph and attempting to accelerate but the vehicle would not respond. The check engine light illuminated as the engine was turned off momentarily and the failure would reset itself until recurring with the illumination of the check engine light. The vehicle was previously taken to the dealer in which a diagnostic test was performed and it was determined that the accelerator had failed. The accelerator pedal was replaced yet the failure recurred. A second diagnostic was performed which also indicated a failure within the accelerator pedal. The dealer was unable to determine the cause of the failure and the vehicle was not repaired. The manufacturer was contacted and informed the contact to take the vehicle back to the dealer and offered no further assistance. The vehicle was not repaired further. Updated 02/23/11 updated 04/28/11.


Other Vehicle Speed Control related problems of the 2006 Subaru Outback



Safety Ratings of Outback Cars
Fuel Economy of Outback Vehicles
Outback Service Bulletins
Outback Safety Recalls
Outback Defect Investigations