Wiring problems of the 2012 Subaru Outback

Two problems related to wiring have been reported for the 2012 Subaru Outback. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2012 Subaru Outback based on all problems reported for the 2012 Outback.

1 Wiring problem

Failure Date: 06/29/2017

The check engine light comes on along with the traction control light. Also, the cruise control and brake light are flashing. I was driving on the interstate in June, 2017 when this happened. This issue first happened in 4/2017. At that time, I was on a trip hours from home driving on the highway in the rain. Dealer repaired a wiring harness under the hood. This just happened again the other day. I have an appointment on 7/5/17. The stored codes are different than in 4/2017.

2 Wiring problem

Failure Date: 07/21/2014

The contact owns a 2012 Subaru Outback. When the vehicle was taken to the dealer for a routine inspection, the mechanic discovered that all four brakes were rusted and needed to be replaced. The vehicle was taken to three other mechanics who did not indicate that the brakes needed replacing. While driving at an unknown speed, the vehicle stalled and was towed to a mechanic. The mechanic stated that someone unplugged and misplaced the wiring under the hood and the clip was fractured. The contact was informed that the clip needed to be replaced and the wires re-adjusted. The vehicle was not repaired and the manufacturer was notified. The approximate failure mileage was 44,000.


Other Electrical System related problems of the 2012 Subaru Outback



Safety Ratings of Outback Cars
Fuel Economy of Outback Vehicles
Outback Service Bulletins
Outback Safety Recalls
Outback Defect Investigations