Front Suspension Hub Problems of Suzuki Forenza

Suzuki Forenza owners have reported 1 problem related to front suspension hub (under the suspension category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Suzuki Forenza based on all problems reported for the Forenza.

1 Front Suspension Hub problem of the 2006 Suzuki Forenza

Failure Date: 01/10/2007

1. 4-26-2006, car repaired, found that the purge valve has an internal failure. R&r purge valve to correct. 2. 10-24-2006, car repaired, found code po705 trans range switch, open intermittent. R&r trans range switch to correct. 3. 12-21-2006, car repaired, power steering light on. Found needle angle sensor part -3721-085z00. Suzuki ordered part and still waiting for the part to be placed in car. 4. 12-29-2006, car repaired. Complaint was roaring noise and rmp needle going close to 5 and heat index exactly in the middle. The only repair done was r&r right wheel bearing in front and replaced hub. When on 1-10-2007 they called to pick up car all repairs done, I went and they told me that the car is sounding worse and it could possibly be a coupling by the tire and that I need a front wheel alignment and that's why I am having all these problems and that there is nothing wrong or found with the rmp needle going close to 5. I drove the car out and talked to another mechanic plus the owner of speedee's and they all laughed, and said that's not right and I would not go back. In driving the car now it really sounds bad and embarrassing, and sometimes it will not go past the speed I'm on while driving unless I release the brakes and press the gas again. The mechanic states not safety issue.

See all problems of the 2006 Suzuki Forenza 🔎.


Other Common Suspension related problems of Suzuki Forenza



Fuel Economy of Forenza Vehicles
Forenza Service Bulletins
Forenza Safety Recalls
Forenza Defect Investigations