Engine Belts And Pulleys problems of the 1999 Suzuki Grand Vitara

Four problems related to engine belts and pulleys have been reported for the 1999 Suzuki Grand Vitara. The most recently reported issues are listed below.

1 Engine Belts And Pulleys problem

Failure Date: 04/05/2004

While driving engine made loud rattling noise and failed. . Aaa called to tow vehicle. Upon inspection by independent mechanic determined timing chain failed. Was mentioned that this was a common failure with this particular vehicle.

2 Engine Belts And Pulleys problem

While driving 65 mph consumer heard a noise coming from the vehicle. Consumer pulled over and inspected the vehicle. Then, vehicle stalled. Consumer tried to restart vehicle, but was unable to do so. Vehicle was towed to the dealer for inspection, and mechanic determined that the timing chain needed to be replaced.

3 Engine Belts And Pulleys problem

While driving the vehicle started making a rattling noise. Upon inspection of the vehicle by the dealership they indicated that the noise was due to the tensioner going bad. The hub bearing and senor also went bad and needed to be replaced at 40,000 miles. Please provide any additional information.

4 Engine Belts And Pulleys problem

The vehicle was taken to the dealer at 30,000 miles because of a "clicking noise" coming from the engine. The dealer stated there was no problem with the engine. The vehicle was then taken to an independent mechanic who found a problem with the tension on the timing chain. The part was on back order.




Safety Ratings of Grand Vitara Cars
Fuel Economy of Grand Vitara Vehicles
Grand Vitara Service Bulletins
Grand Vitara Safety Recalls
Grand Vitara Defect Investigations