general problems of the 2007 Toyota 4Runner

Four problems related to structure have been reported for the 2007 Toyota 4Runner. The most recently reported issues are listed below. Please also check out the statistics and reliability analysis of the 2007 Toyota 4Runner based on all problems reported for the 2007 4Runner.

1 Structure problem

Failure Date: 04/02/2013

The rear hatch door handle turned into a melted rubber/plastic mess. Our hands are covered with black melted rubber type material whenever we try to open the rear hatch. After online research, I see there are allot of other Toyota 4 runners with the same problem. The part is called, switch assembly, back part #84840-35010. No doubt that the part is faulty.

2 Structure problem

Failure Date: 08/03/2012

The pad (located on the hatchback latch) where you place your hand to press down to open the hatchback has melted. It is difficult to open the hatchback as the rubber has melted & the button no longer releases properly. When I called don mcgill Toyota in houston, TX, they explained this is not a recall item & it would cost approximately $350 to repair since it includes replacing the entire button & electrical parts associated with the hatchback. This is a safety issue since I cannot open the hatchback properly. I believe this is a faulty hatchback handle which Toyota should repair at no charge. The parts that were originally used on this handle are faulty.

3 Structure problem

Failure Date: 08/24/2009

The back, trunk handle switch consists of a black, rubber type of material that melts every summer. I live in texas so summers can get extremely hot. So, it has melted/gotten hot to the point where it almost burned me and my husband's fingers. Additionally, it will leave black stains on our fingers regardless of the weather. This is not only an inconvenience but also a hazard. I'm currently trying to get it fixed at the dealership. However, I was told that the part that would replace it is the same material. So, I'm writing this to hopefully get a response from Toyota to replace these handles with another type of material. I've researched online and have found that it is not only with 4runners that this happens on but also siennas. We should not have to experience this with any vehicles we purchase regardless of where we live. Toyota should do something about this issue and not expect customers to just fix it on their own, not to mention replace it with the same switch that we had issues on to begin with.

4 Structure problem

Failure Date: 04/01/2008

2007 Toyota 4 runner with bad ground clearance. Consumer states that the vehicle scrapes the ground. Toyota reps and service reps keep telling her that ground clearance is measured different ways. The consumer stated she wanted a vehicle with high ground clearance. The dealer told her the vehicle had 9. 1 inches of ground clearance, but later the consumer discovered that wasn't true.


Other Structure related problems of the 2007 Toyota 4Runner



Safety Ratings of 4Runner Cars
Fuel Economy of 4Runner Vehicles
4Runner Service Bulletins
4Runner Safety Recalls
4Runner Defect Investigations